Oki Pro1040 - [Admin Setup]

- 63 -
Table of Setting Items in the Control Panel Menu Screen
[Admin Setup]
Note
z
To enter this menu, it is necessary to enter the [Password].
z
The factory default setting of the administrator password is [999999].

Network Setup
z
Shaded areas are factory-set values.
Item Value Description
TCP/IP Enable
Disable
Enables/disables TCP/IP protocols.
NetBIOS over TCP
*1
Enable
Disable
Enables/disables NetBIOS over TCP/IP.
IP Address Set
*1
Auto
Manual
Specifies whether to request the IP address
from the DHCP server.
IPv4 Address
*1 *2
xxx.xxx.xxx.
xxx
Sets the IP address.
Subnet Mask
*1 *2
xxx.xxx.xxx.
xxx
Sets the subnet mask.
Gateway Address
*1 *2
xxx.xxx.xxx.
xxx
Sets the gateway address.
Web
*1
Enable
Disable
Enables/disables access using web browsers.
Telnet
*1
Enable
Disable
Enables/disables access using Telnet.
FTP
*1
Enable
Disable
Enables/disables access using FTP.
IPSec
*1
Enable
Disable
Enables/disables access using IPsec.
SNMP
*1
Enable
Disable
Enables/disables access using SNMP.
Network Scale Normal
Small
Normal:
Printer operates effectively even if
connected to a hub with spanning tree
functions. However, printer startup
time becomes longer when two or three
computers are connected to a small-scale
LAN.
Small:
Covers small scale LANs with 2 or 3 PCs
to large scale LANs are covered, but if
connected to a hub with spanning tree
functions, operations may not be effective.
Gigabit Network Enable
Disable
Sets whether to support a Gigabit network.
Hub Link Setting Auto Negotiate
100Base-TX Full
100Base-TX Half
10Base-T Full
10Base-T Half
Sets the connection mode to the hub.
Network Factory Defaults Execute Restores the settings, such as network, mail
server, LDAP server, and secure protocol
server, etc., to their default values.
*1: Appears when [Enable] is set on the control panel for [TCP/IP].
*2: Appears when [Manual] is set on the control panel for [IP Address Set].