- 33 -
Calibrating the Sensor
Printer
1
Grasping the Top Cover Open Lever,
open the Top Cover.
2
Remove the Print Cartridge Set and the
Belt Unit.
Memo
z
Refer to “Maintenance Guide” for the procedure to
install the print cartridge set and belt unit.
3
Confirm the sensor position.
Sensor Position Adjustment Dial
Position During
Regular Usage
Factory setting
is this position.
The “│” indicates the
gap sensor position
Edge
of
paper
The “
∆
” indicates the
black mark sensor
position
65 mm from
edge of paper
58.5 mm from edge
of paper
To Next Page
Loading...
