Oki Pro1040 - Page 32

- 32 -
Calibrating the Sensor
If the position of the label and the
gap sensor position do not align
in relation to the regular usage
position, rotate the Sensor Position
Adjustment Dial to adjust the
position (go to step 3).
Label
5mm
Width of the
right edge
of the liner
The gap sensor position is set 16.5
mm from the edge of the paper.
If the width of the right edge of
the liner is 10 mm or less, then
adjustments are not necessary.
If the width of the right edge of the
liner is 10 mm or more, then adjust
the gap sensor using the above
positions as a rough estimate.
If the corners of the label are
rounded, then consider the position
of the radius of the corner.
Refer to the following example of
adjusting the position.
Label
Radius of
corner
5mm
3
Rotate the Sensor Position Adjustment
Dial to adjust the sensor position.
A
B
D
C
Memo
z
If you rotate the Sensor Position Adjustment Dial in
direction A
→
the sensor position moves in the
direction C
direction B
→
the sensor position moves in the
direction D