Oki Pro1040 - Page 173

- 173 -
Using a Web Browser to Configure the Network Setup
4
Under [STEP1], select [Enable] for
[SMTP Send].
5
Under [STEP2], specify the required
addresses.
(1)
For [SMTP Server], specify the mail
server domain name or IP address.
(2)
For [Printer Email Address], specify
the mail address assigned to the
printer.
Note
z
To configure SMTP server settings with a domain
name, you need to configure DNS server settings
with the [TCP/IP] setup.
z
The mail server needs to be configured to allow
the printer to send mail. For information about
mail server settings, consult with your network
administrator.
z
Internet Explorer 7 configured with its initial default
setup will not perform a send test.
To perform a send test, you need to change the
setup of Internet Explorer 7.
Select [Tools] > [Security Level Customization],
and then enable [Allow websites to prompt for
information using scripted windows].
6
To configure more advanced settings
from this point, click [Set detail of the
SMTP Protocol.] for [STEP3].
Otherwise, jump to step 16 of this
procedure.
7
Click [Security Settings].
8
For [SMTP Port Number], specify the
mail server port number.
9
Select [Enable] for [SMTP-Auth].
(1)
For [User ID], specify the user ID
for connection to the mail server.
(2)
For [Password], specify the
password for connection to the
mail server.
10
Click [OK].
11
Click [Configure attached information].