- 177 -
Using a Web Browser to Configure the Network Setup
5
Under [Setting Events Used for Sending
Email Alerts], select the check boxes of
the error types for you to be notified of.
6
Specify the delay after an error occurs
until the message is sent, and then click
[OK].
Memo
z
Setting a delay time makes it possible to send
notifications only of errors that are generated only
over a long period of time.
z
Setting "0 hours, 0 minutes" for the delay time,
causes the message to be sent immediately after an
error occurs.
7
Click [OK].
8
Check the configuration of the
malfunction notification conditions.
z
To display as a list
(1)
Click [Show current settings table].
(2)
Check the configuration, and then
close the window.
z
To compare the setting conditions of two
recipients
(1)
Use the list box to select each
of the recipients you want to
compare.
(2)
Check the displayed configuration.
Memo
z
You can change notification condition settings by
clicking inside the setting condition comparison
table.
9
Click [Submit].
10
Settings are saved on the printer and
the network function is restarted.
To Next Page
Loading...
