- 29 -
Loading Media
Gap is too large
Roll Paper Guide is aligned to width of paper
Roll Paper Guide is too tight
19
Close the Unwinder Cover.
Note
z
When closing the Unwinder Cover, there is a risk of
pinching your fingers or hands. Press the top of the
Unwinder Cover to close it.
This completes setting roll paper.
Memo
z
If, even though the roll paper is set correctly, the
paper separates from the Unwinder Paper Guide
during printing, rotate the Roll Paper Position
Adjustment Dial in the B direction to adjust it so the
paper does not separate from the Unwinder Paper
Guide.
As a guideline, the adjustment should be the same
distance that the paper is separated from the
Unwinder Paper Guide.
Each notch on the adjustment scale at the base of
the Roll Paper Position Adjustment Dial is 1 mm.
Adjustment notches
A
B
To Next Page
Loading...
