Oki Pro1040 - Page 39

- 39 -
Calibrating the Sensor
9
Press the <Fn> key, and then press
the following buttons: <8>, <9>, <0>,
<OK>.
10
Select [Black Mark Interval] from
[Unwinder Config], and then press the
<OK> button.
11
Use the numeric keypad to enter the
Black Mark Interval, press the <OK>
button, and then press the <ON LINE>
button.
The display will return to the standby
screen.
12
Press the <Fn> key, and then press
the following buttons: <8>, <9>, <3>,
<OK>.
13
Select the setting number of the sensor
to be configured, and then press the
<OK> button.
14
Select [Execute Calibration], and then
press the <OK> button.
15
Enter the sensor calibration name, and
then press the <OK> button.
Memo
z
You can leave the name blank, if you want.
16
If an execution confirmation screen
appears, select [Yes].
17
This executes sensor calibration.