Oki Pro1040 - Page 41

- 41 -
Calibrating the Sensor
5
Press the <Fn> key, and then press the
following buttons: <9>, <0>, <OK>.
6
On the Paper Size menu, select
[Custom], press the <OK> button, and
then press the <ON LINE> button.
The display will return to the standby
screen.
7
Press the <Fn> key, and then press the
following buttons: <9>, <1>, <OK>.
8
Use the numeric keypad to enter the
label width, press the <OK> button,
and then press the <ON LINE> button.
The display will return to the standby
screen.
9
Press the <Fn> key, and then press the
following buttons: <9>, <2>, <OK>.
10
Use the numeric keypad to enter the
label length, press the <OK> button,
and then press the <ON LINE> button.
The display will return to the standby
screen.
11
Press <8>, <9>, <0> (function
numbers), and then press the <OK>
button.
12
Select [Gap Length] from [Unwinder
Config], and then press the <OK>
button.