Oki Pro1040 - Page 54

- 54 -
Table of Setting Items in the Control Panel Menu Screen
Item Value Description
Y Dimension 12.7 millimeter
(0.50 inch)
～
101.6 millimeter
(4.00 inch)
～
148.0 millimeter
(5.83 inch)
152.4 millimeter
(6.00 inch)
～
1320.8 millimeter
(52.00 inch)
Sets the length of the custom paper sizes
for the unwinder.
Sets the same direction as for the
dimension in the paper feed direction.
If the setting is 101.6 mm (4.00 inch) or
lower, then the set page length is handled
as a whole-number multiple of the actual
length of the page such that it exceeds
101.6 mm (4.00 inch).
The initial values vary depending on your
operating environment.
Appears when the Media Form is
[Continuous Paper], [Die-cut Label
(Gap)], [Die-cut Label (Black Mark)] or
[Continuous Label].
Black Mark Interval 15.9 millimeter
(0.63 inch)
～
101.6 millimeter
(4.00 inch)
～
151.2 millimeter
(5.95 inch)
155.6 millimeter
(6.13 inch)
～
1324.0 millimeter
(52.13 inch)
Sets the interval of the marks on custom
paper for the unwinder.
Sets the same direction as for the
dimension in the paper feed direction.
If the setting is 104.8 mm (4.13 inch) or
lower, then the set page length is handled
as a whole-number multiple of the actual
length of the page such that it exceeds
101.6 mm (4.00 inch).
The initial values vary depending on your
operating environment.
Appears when the Media Form is
[Continuous Paper (Black Mark)] or
[Continuous Label (Black Mark)].
Gap Length 3.0 millimeter
(0.12 inch)
～
10.0 millimeter
(0.39 inch)
Sets the interval for labels.
Sets the same direction as for the
dimension in the paper feed direction.
Appears when the Media Form
is [Die-cut Label (Gap)] or
[Die-cut Label (Black Mark)].
Adjust Cut Position -0.5 millimeter
(-0.02 inch)
～
0.0 millimeter
(0.00 inch)
～
+0.5 millimeter
(+0.02 inch)
Specifies the compensation value for
the distance from the print completion
position to the cut position (beginning of
next label). (Specifies margin on following
edge)
If you specify a negative value, cutting is
done at a short position.
z
Shaded areas are factory-set values.