XZAC4219-05 Service Manual
III
PREFACE
This manual for Service engineers supplies all the technical information required for installing, testing and carrying
out maintenance interventions on the specialised PR2 PLUS printer.
This manual can help you resolve a printer malfunctioning problem, when the solutions proposed in the Operating
Manual provided in the printer kit are not successful.
SUMMARY
The manual is subdivided into 8 chapters and an Appendix:
•
Chapter 1 Introduction
- provides information of a general nature on the printer.
•
Chapter 2 Installation
- describes the procedures and standards to follow for installing the printer.
•
Chapter 3 Operating the Printer
- examines the operating procedures to follow to operate the printer correctly.
•
Chapter 4 Programming and Calibration
- describes the procedures for programming the printer and
calibrating it.
•
Chapter 5 Diagnostics
-all the defects that can be detected by the printer's diagnostics system are listed here.
•
Chapter 6 Maintenance
- an illustrated procedure describes the cleaning, lubrication and mechanical adjustments
that may be necessary for the printer.
•
Chapter 7 Disassembling and Reassembling Parts
- describes the procedures for disassembling and
reassembling again the main components of the printer.
•
Chapter 8 Installing the Printer Options
- provides the procedures for installing additional features of the printer.
•
Appendix
- provides information regarding obtaining spare parts, and the software installed on the printer. An
illustrated procedure also describes how to update the printer firmware.
PRE-REQUISITES
The approach to the topics covered in this manual requires knowledge of similar products.
TECHNICAL SUPPORT CONTACTS
Email address: Banking.Printers@Olivetti.com
WEB Site: www.Olinet.biz
REFERENCES
Spare parts catalogue - cod. XZAC3455
DISTRIBUTION: General
FIFTH EDITION: November 2010
To Next Page
Loading...
Need help?
General
