Olivetti PR2 plus - Description of Configuration Parameters

4-6 Service Manual
XZAC4219-05
Description of configuration parameters
In this section the configuration parameters present in the programming menu are listed, with the various values
that can be set and their meanings. Values set by default are indicated in bold and highlighted with an asterisk.
Configuration mode menu "MENU: CONFIG." parameters
Parameter Values possible Description
DRAFT SPEED
NORMAL * Normal printing speed 370 cps
HIGH High printing speed 510 cps
VERY HIGH Very high printing speed 560 cps
LQ TYPE
LQ2 Letter Quality 125 cps
NL Q1 * Near Letter Quality type 1 185 cps
NL Q2 Near Letter Quality type 1 185 cps
PAPER WIDTH
FIRST LINE *
The width of the document is measured on the first line
printed
PROGRAMMABLE
The position used for measuring the width of the
document can be programmed
BUZZER
NO Switches the buzzer on
YES * Switches the buzzer off
INTERFACE
USB
System connection interface. Depending on the
interface selected, the related parameters indicated in
the tables below can be configured. See
page 4-7
SERIAL1 See page 4-8
PARALLEL See page 4-8
COM1-USB See page 4-9
USB - PAR See page 4-9
DUAL-PAR See page 4-9
SCAN F_BRIGHT
From - 60 % to + 60 %
with step from 10 % -
default + 0%
SCAN R_BRIGHT
From - 60 % to + 60 %
with step from 10 % -
default + 0%
PAP. EDGE DETEC.
N
Y