Chapter 7
7-31
Configurator Settings
■ Monitoring Methods
● Using the Monitor Device Window
• Click the OUT Tab or IN Tab in the Monitor Device Window to monitor in outputs/inputs.
• The following information will be displayed.
Note 1. The monitoring items in the IN Tab Page are similar to the OUT Tab Page. The numeric val-
ues in the No. field, however, indicate each input terminal. (Refer to page 7-29.)
Note 2. The ON/OFF status of the Connected Component Maintenance Flag can be checked on the
General Tab Page of the Monitor Device Window. When this flag is ON, the Connected Com-
ponent Maintenance check box will be selected.
Item Details
No. The settings in the No. field are as follows:
00: Multi-function contact output, 01: Multi-function output 1, 02: Multi-function
output 2
Note: When the present value of the maintenance counter (total ON time or con-
tact operations counter) exceeds the monitor value, the error icon is displayed on
the left side of the corresponding No. setting.
I/O Comment Displays the comment for the connected device for each output terminal.
ON/OFF Displays the ON/OFF status (present value status) for each output terminal.
Maintenance Counter Displays the present value of the maintenance counter for each output terminal.
Note: The total ON time (s) or contact operations count (No. of times) is dis-
played.
Clear Value Button Clears the present value of the maintenance counter to zero.
Note: Select the terminal to be cleared, click the Clear Value Button to clear the
value to zero.
OUT Tab Page in the
Monitor Device
Window
To Next Page
Loading...
