Chapter 7
7-59
Configurator Settings
7-4-4 Operation Time Tab Page
Note The following table shows the meanings of the values set in the No. field]
Note For details on measurement methods, refer to 7-2-5 Operating Time Monitor Function.
Item Details Reference
No. Refer to the following table for meanings in the No. field. (For details, refer
to 7-2-5 Operating Time Monitor Function.)
Note: When the operating time exceeds the monitor value, an error icon is
displayed to the left of the corresponding setting in the No. field.
7-2-5 Operating Time
Monitor Function
Equipment Name Displays the name of each device.
Response Time Displays the operating time of each device.
Peak Value Displays the maximum value of the operating time of each device.
Clear Error Button Clears the Operation Time Over Flag in the Unit’s Status Area.
Note 1: This button is enabled when Status Hold is selected on the Oper-
ation Time Tab Page of the Edit Device Parameters Window.
Note 2: Select the device to be cleared, and then click the Clear Error But-
ton to set the Flag to OFF.
Clear Peak Value
Button
Clears the peak operating time value to zero.
Note: Select the device to be cleared, and then click the Clear Peak But-
ton to clear the setting to zero.
No. Operating time measurement trigger
Conditions for starting measurement Conditions for ending
measurement
00 Multi-function contact output: ON Input 4: ON
01 Multi-function output 1: ON Input 5: ON
02 Input 2: ON Input 3: ON
03 Input 4: ON Input 5: ON
04 Input 0: ON or Input 1: ON
or when a forward/reverse run command is sent
Input 4: ON
05 Input 0: ON or Input 1: ON
or when a forward/reverse run command is sent
Input 5: ON
To Next Page
Loading...
