Chapter 7
7-64
Configurator Settings
Note The maintenance information is saved in the EEPROM approximately every six minutes.
Therefore, depending on the power OFF timing, up to six minutes worth of data is lost. To mon-
itor more closely, click the Save Maintenance Counter Button immediately before turning OFF
the power. The maintenance information will be written to the EEPROM.
Unit Sta-
tus Report
Area
Unit Maintenance Notifies that the Inverter’s operation time has
exceeded the monitor value.
7-2-8 Conduction Time
Monitor
Fan Maintenance Notifies that the fan’s operation time has
exceeded the monitor value.
Electrolytic Capac-
itor Maintenance
Notifies that the electrolytic capacitor’s opera-
tion time has exceeded the monitor value.
Network Power
Voltage Drop
Notifies that the network power voltage has
dropped below the monitor value.
7-2-9 Network Power Sup-
ply Voltage Monitor
Operation Time
Over
Notifies that the operation time has exceeded
the monitor value.
7-2-5 Operating Time Mon-
itor Function
Connected Com-
ponent Mainte-
nance
Notifies that the total ON time or contact opera-
tions count for the I/O terminals has exceeded
the monitor value.
7-2-6 Cumulative ON Time
Monitor
7-2-7 Contact Operations
Monitor
Warning Notifies that a warning or error has occurred in
the Inverter (the details are also displayed).
---
During Forward
Run/During
Reverse Run
Notifies that the Inverter is operating in forward/
reverse run mode.
---
Frequency Agree Notifies that the Inverter is agreement frequen-
cies.
---
Update Button Uploads all the maintenance information
(including information from other tab pages)
and refreshes the screen.
---
Save Maintenance Counter
Button
Writes the maintenance counter information
(operating time and maintenance counter for
each terminal) to the EEPROM of the
DeviceNet Communications Unit/Card.
---
Item Details Reference
To Next Page
Loading...
