Chapter 10
10-73
Appendices
10-6-3 Parameter Reading and Writing
The following tables show the SYSDRIVE 3G3PV Inverter parameter and the corresponding register
numbers. Write and read the various parameters with “1" as the minimum setting unit. Negative num-
bers are expressed as two's complement. If the setting unit is in hexadecimal, there is no need to
convert it.
When writing data in parameters, be sure to send an enter command to enable the written data.
Unless the enter command is transmitted, the data will not be enabled and the Inverter may not start.
08 09 0809 Content of
10th prior
fault
Monitors U3-14 (same codes as U2-01) (See note.)
08 0E 080E Cumulative
operation
time since
5th prior fault
Monitors U3-15; 1-hr units (See note.)
08 0F 080F Cumulative
operation
time since
6th prior fault
Monitors U3-16; 1-hr units (See note.)
08 10 0810 Cumulative
operation
time since
7th prior fault
Monitors U3-17; 1-hr units (See note.)
08 11 0811 Cumulative
operation
time since
8th prior fault
Monitors U3-18; 1-hr units (See note.)
08 12 0812 Cumulative
operation
time since
9th prior fault
Monitors U3-19; 1-hr units (See note.)
08 13 0813 Cumulative
operation
time since
10th prior
fault
Monitors U3-20; 1-hr units (See note.)
Class 64 Register No.
(Hex)
Contents
In-
stance
At-
tribute
To Next Page
Loading...
