Omron fh-1 series - Page 131

4 - 33
4 Setting the Controller
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
4-4 Setting Operation Mode [Startup Settings]
4
4-4-2 Parallel Processing
 Flow of Images
• The image at the start of parallel processing is passed on to the next item for use in each task block.
• The image for the start of parallel operation is also the image that is used after the Parallelize End
processing item.
• Note that you cannot assign any Camera Image Input processing item within task blocks.
To change the Camera image, you must use the Camera Switching processing item and set a differ-
ent Camera number.
Flow of Images
Image 1
Camera Image Input
Parallelize
Parallelize End
Filtering Search
Camera Switching
Back ground
suppression
Search
Parallelize Task
Image 2
Image 1
Image 2
Image 2
Image 2
Image 1
Search
Search Search
Position Compensation
Image 4
Color Gray Filter
Defect
Image 5
Parallelize Task
Image 2
Parallelize Task
Image 2
Parallelize Task
Image 2
Image 1
Image 2
Image 4
Image 2
Image 3
Image 2
Parallel Block
Search
Position Compensation
Image 6
Image 2