9 Saving/Loading Data
9 - 18
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
Necessary steps prior to launching Configuration Copy are explained here.
1 Connect the external storage device to the Sensor Controller.
2 From the [Tool] menu in the main window, select [Configuration Copy].
3 [Confirm] dialog box is displayed.
Click [Continue] button.
The Setting data for the line 0 and Common setting will be saved and the Configuration Copy
function will be launched.
• In the case of multi-line random trigger mode,
When not be saved the data of the line 0 to 7 for back up, please click [Cancel] button. If you
click [Continue] button, the setting data of the line 0 to 7 can not be saved. Launch the Config-
uration Copy function after [Data Save] for all lines.
If settings have been modified and you do not want to include the modifications in the sensor
controller project, click the [Continue without save] button and the pre-edited settings will be
saved to the project.
This section explains the procedures for selecting the settings to backup
1 Click [Save] tab.
Launching Configuration Copy
Selecting the Settings to Back up
To Next Page
Loading...
