9 Saving/Loading Data
9 - 42
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
This explains the steps for applying Copy/Clear operations on setting data to the sensor controller.
1 After a Copy/Clear operation on all setting data is complete, click the [Apply] button.
2 The following Confirm screen is displayed.
After confirming the After revision setting data is correct, click the [OK] button.
The setting data selected for Copy/Clear will be applied to the sensor controller. The applied
settings can not revert to the previous state.
• Setting data is being applied. Do not turn off power. Doing so may cause the sensor control-
ler not to operate properly.
• Do not disconnect the external storage device while using the Line Maintenance tool. Doing
so could corrupt the data in the external storage device, or cause the sensor controller not to
operate properly.
3 Click [Close].
4 The following Confirm screen will display.
Click [OK]. The sensor controller will automatically restart.
• If, after a Copy/Clear operation is done and [Apply] is not selected, the following dialogue will
be displayed when closing the tool.
• If the setting data selected for Copy/Clear has not been applied, click the [OK] button. The
sensor controller will automatically restart.
• If the setting data selected for Copy/Clear has been applied, click the [Cancel] button. Return
to Step 1 and click the [Apply] button.
Applying Copy/Clear Operations
To Next Page
Loading...
