Omron fh-1 series User Manual

10 - 9
10 Advanced Usage
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
10-1 Remotely Operating the Controller
[Remote Operation]
10
10-1-1 Environment Settings
6 Select your target Sensor Controller in the list and click [Set Network].
7 Set the IP address for the Sensor Controller on the "Network setting".
8 Click [OK].
The IP address is set to the Sensor Controller.
9 On the network reference list, click [Refresh] to check the IP address setting is reflected.
Precautions for Correct Use
The reflection of IP address settings may take time. If it were not reflected, click [Refresh]
again.
Precautions for Correct Use
If a bad IP address or an IP address overlapped with a device on the same network are set, an
IP address different from your Setting will be displayed on the list like (169.254. xx. xx). Perform
this procedure to set a valid IP address.

Omron fh-1 series Specifications

General

Brand	Omron
Model	fh-1 series
Category	Machine Vision Systems
Language	English