Omron fh-1 series User Manual

10 Advanced Usage
10 - 8
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
 Network Settings for Sensor Controller (With Remote Operation PC)
Precautions for Correct Use
The network settings for the Sensor Controller set with this procedure is temporary. Since the
settings are discarded with restarting the Sensor Controller or power off, follow the procedures
of Network Settings for Remote Operation PC on page 10-6 after the remote operation connec-
tion.
1 From the [Start] menu on your PC, select [All Programs] - [OMRON] - [FZ_FH Series] -
[FH_FHV Launcher].
FH/FHV Launcher window appears.
2 Click the [Remote Operation Tool] button.
3 In the [Version], select the version of the measurement application of the sensor controller to be
controlled remotely.
4 Click the [Run] button.
Note that the Sensor Controller must be placed in a measurement capable state.
Precautions for Correct Use
Do not connect or disconnect the [Remote Operation Tool] during a measurement or the sys-
tem running.
5 Click [Browse].
A "Network reference" list will be displayed.
When you run the simulation software of the sensor controller on the remote operation side PC,
the simulation software information may be displayed in the Network reference list.

Omron fh-1 series Specifications

General

Brand	Omron
Model	fh-1 series
Category	Machine Vision Systems
Language	English