10 Advanced Usage
10 - 6
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
Perform the network settings on the Sensor Controller and the remote operation PC respectively.
If the network address part of an IP address for the Sensor Controller is different from that for the
remote operation PC, the connection for the remote operation is not available.
With the remote operation PC, the network settings for the Sensor Controller is possible. For
details, refer to the Network Settings for Sensor Controller (With Remote Operation PC) on
page 10-8.
For FHV series, follow the above procedures to set the network for the Sensor Controller.
Network Settings for Remote Operation PC
Set the IP address for the remote operation PC.
1 Open the "Local Area Connection Properties" on the remote operation PC.
2 Input the IP address.
Setting Network
To Next Page
Loading...
