10 - 63
10 Advanced Usage
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
10-9 Positioning workpieces for stage and
robot applications [Alignment Function]
10
10-9-4 Alignment
When failed to measure such as an alignment mark, an operator directly and
manually specifies the coordinates.
When failed to measure such as an alignment mark, an operator can specify the coordinates manu-
ally and directly by using the Manual Position Setting processing unit function in combination with a
processing unit such as “Search” to detect an alignment mark.
There are two ways to launch the Manual Position Setting function.
• Communication command startup
Higher-level devices such as PLC check a transmitted measurement data from the Sensor con-
troller. If the Position Setting Request flag was set, then the device judge the measurement failed
and send a measurement command for re-measurement. The command opens the Manual Posi-
tion Setting screen.
• Auto startup during measurement
When a judgement result of a processing unit such as “Search” became NG, the Manual Position
Setting processing unit opens the Manual Position Setting screen.
Communication command startup:
Other Alignment Functions
To Next Page
Loading...
