Parker Compax3 Series User Manual

Setting up Compax3 C3I22T11
162 192-120114 N5 C3I22T11 June 2008
Cursormodes/ -functions
Depending on the operating mode, different cursor functions are available within
the osci monitor.
The functions can be changed sequentially by pressing on the right mouse button.
Cursor Symbol Function
Set Marker 1
the measurement values of the active channel as well as the y diffe-
rence to marker 2 are displayed
Set Marker 2
Delete and hide marker
Move offset of the active channel.
The yellow symbol indicates that the scrolling is active.
Set trigger level and pretrigger
In the ROLL operating mode, marker functions and set trigger level positions are
not available.
4.3.2.2 User interface
In this chapter you can read about:
Oscilloscope operating mode switch: .............................................................................. 163
Setting the time basis XDIV ............................................................................................. 163
Settings for channels 1..4 ................................................................................................ 164
Trigger settings ................................................................................................................ 165
Special functions.............................................................................................................. 165

Parker Compax3 Series Specifications

General

Enclosure Rating	IP20
Control Modes	Speed, Torque, Position
Communication Interfaces	CANopen, EtherCAT
Feedback Options	Incremental Encoder, Resolver
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Cooling Method	Forced Air, Natural Convection
Relative Humidity	5 to 85 %, non-condensing
Operating Temperature	0 to +45 °C (derating may apply above 40°C)