Particle Measuring Systems LASAIR II 310 User Manual

C Commands
Lasair II Particle Counter Operations Manual Page G-5
54 Time Series Channel
56 Manifold Sequence Enable
57 Manifold Sequence Length
58 Alarm Count Port Num.
59 Search Length Hours
60 Mixed Air Alarm Enable
61 Mixed Air Alarm Print
63 Search Alarm Print On/Off
C Command Table Format
These commands are from the C command above. All of these commands are
redundant, and are provided for users of existing Lasair II particle counters who
want to simplify their upgrade path. Some of these commands split internal
variables into several pieces. For instance “C 0” through “C 6” are used to set date
and time. Because of the variable split, unexpected results can be obtained if the
user is not careful with software coding. For instance, setting the date and time in
multiple parts has the possibility of time-rollover in-between settings. In other
words, if the Lasair II particle counter seconds rolls over from 59 to 0, then at a
minimum the minutes will also change, and if this occurs right after setting the
minutes, then the expected time will be wrong.
Command Format
C nn sssssssssss
where:
C nn = command # (0-38)
sssssssssss = any alphanumeric entry appropriate to the parameter being
defined.

Particle Measuring Systems LASAIR II 310 Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 310
Category	Measuring Instruments
Language	English