Particle Measuring Systems LASAIR II 310 User Manual

Appendix G: Native Serial (RS-2332) Communications
Page G-2 Lasair II Particle Counter Operations Manual
Error A command failed due to other circumstances. The most likely cause is
that the serial interface did not execute the “KB 1” command to lock-out keyboard
control, and someone is using the front panel controls. This message can also be
caused by a parameter out of range.
Error --Range The following commands have a parameter out-of- range:
• TN
• ANID
• AUTOSTART
• C 10
Lasair Upgrade Information
The original Lasair had a somewhat terse interface, hence users who want to
upgrade their own software must handle the fundamental interface changes. The
following is a quick list of supported commands from the Lasair, with notes about
any differences.
The following command is not supported:
R Retransmit sample in last group.
Commands Supported from the Lasair
SS Start Sampling
ES End Sampling
SN Set to continuous sampling
C Change/setup command (see additional information below).
KB Keyboard lockout command. This is retained through a power
cycle.
KG Keyboard lockout until power cycle.
TI Set sample interval
TD Set time/date
ID Set instrument ID.

Particle Measuring Systems LASAIR II 310 Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 310
Category	Measuring Instruments
Language	English