Running an Assay 33
P/N CLS151164 Rev. B LabChip GX Touch/GXII Touch User Manual PerkinElmer, Inc.
Defining the Run Parameters
To define the run parameters:
1 Touch the Home button and then touch the Run button.
If the maximum number of samples for the chip have already
been run, a message displays instructions for resolving the
problem.
The Select Wells Tab opens.
2 Select the assay to run in the Select Assay drop-down list. If
the desired assay is not displayed, touch the Change Assay
Folder button and select the assay folder in the Change Assay
Folder Window.
3 Select the plate type in the Select Plate Type drop-down list. To
use a plate that is not listed in the Plate Name list, see Defining
a New Plate Type on page 29.
4 To use an existing run file to specify the run settings, touch the
Import Run File button, navigate to the run file, select the
desired file, and touch the Open button. The settings specified
in the run file display in the Select Wells Tab and Setup Run
Tab. To use the settings in the run file, touch the Next button
twice and skip to step 26. For more information about run files,
see page 54.
5 To sample the wells in the order in which the wells are selected
in the plate diagram, select the Selection Sip Order check box
before selecting the wells.
6 On the Plate diagram, select the wells to be sampled.
• If desired, touch the Full Size button to enlarge the Plate
diagram to better view and select the desired wells.
• To select or clear all rows on the plate, touch the Select All
Rows button at the top left corner of the plate.
• To select or clear all wells in a row, touch the row letter on
the left side of the plate. (Clear a selected row by touching
the row letter.)
• To select or clear a single column, touch the column number
at the top of the plate. (Clear a selected column by touching
the column number.)
• To select or clear all wells in a quadrant, touch the 1, 2, 3, or
4 button.
• To select or clear single wells, touch the well.
To Next Page
Loading...
Need help?
General
