Software Reference 87
P/N CLS151164 Rev. B LabChip GX Touch/GXII Touch User Manual PerkinElmer, Inc.
Status Window (Continued)
• Assay - The name of the assay for which the instrument will be
calibrated.
• Status - The current step of the operation in progress. For
completed operations, displays the status of the last operation.
• Step Time Left - The time remaining until the current step in the
priming/calibration completes.
• Run Time Left - The time remaining until the current run in the
priming/calibration completes.
• Maximum Calib. Time - The maximum amount of time
remaining until the priming/calibration completes.
Run Status - Displays the current status of the assay, prime, or
wash that is currently running or about the last completed
operation.
• Assay - The name of the assay that is running or that generated
the displayed data.
• Status - The current step of the operation in progress. For
completed operations, displays the status of the last operation.
• Step Time Left - The time remaining in the current step in the
run.
• Run Time Left - The time remaining until the assay is complete.
• Barcode - Displays the barcode number if Use Barcode is
selected in the Setup Run Tab. Displays N/A if Use Barcode is
not selected in the Setup Run Tab.
• Current Cycle - Displays <CurrentPlateCycle>/
<TotalPlateCycle>, where CurrentPlateCycle is the number of
the plate cycle currently executing and TotalPlateCycle is the
total number of plate cycles specified in the Select Wells Tab.
CurrentPlateCycle displays 0 during the priming and warming
steps before reading the first well. Does not display if only one
cycle is selected.
Plate Diagram - Displays the wells selected for the run in progress
or the last completed run. Does not display for ProteinEXact chips.
• Blue wells - Well has been read.
• Red exclamation point in wells - An analysis error has
occurred in the well, such as no lower marker detected.
• Flashing green/orange - Well reading is in process.
• Green - Well is selected for reading but not read yet.
• Gray - Well is not selected to be read.
To Next Page
Loading...
Need help?
General
