Pitney Bowes Connect+ 1000 - Page 205

Chapter 9
been vertically aligned to print on envelopes. Select Next to continue to the horizontal
alignment.
7. Place an envelope on the feed deck and select Start to print the first horizontal test pat-
tern.
8. Select the Pattern number: field.
a. Enter the number of the best aligned pattern.
b. Select OK.
c. Select Next to continue.
9. Repeat steps 7 and 8 to print the second horizontal test pattern.
10. If the alignment was successful, a message appears indicating that the print heads have
been aligned to print on envelopes. Select Done.
Tape Alignment Only
1. Select Tape to print the first vertical test pattern.
a. Select the Pattern number: field.
b. Enter the number of the best aligned pattern.
c. Select OK.
d. Select Next to continue.
2. Repeat step 1 to print the second vertical test pattern.
3.
If the alignment was successful, a message appears indicating that the print heads have
been vertically aligned to print on tape. Select Next to continue to the horizontal align-
ment.
4. Select Tape to print the first horizontal test pattern.
a. Select the Pattern number: field.
b. Enter the number of the best aligned pattern.
c. Select OK.
d. Select Next to continue.
5. Repeat step 4 to print the second horizontal test pattern.
6. If the alignment was successful, a message appears indicating that the print heads have
been aligned to print on tape. Select Done.
201
SV62250 Rev. G