MULTI GAUGE CONTROLLER INTRODUCTION
1 INTRODUCTION
Please read this manual carefully to ensure the optimum operating conditions and safety of the
user. This user manual handbook contains important information about functionality, installation,
start-up and operation of the MG15 device.
1.1 INFORMATION ABOUT VERSION - RELEASE NOTE
Information about MG15 device version can be found at www.prevac.eu, in the DOWNLOAD tab.
There is information about any possible changes in subsequent versions of the device or software.
1.2 INTENDED USE
The MG15 multi gauge controller is a universal devices controlled by a microprocessor, able to sup-
port several types of pressure gauges in a range of 2 ⋅ 10
mbar to 2 ⋅ 10
mbar (depending on the
gauge used). The concept and design of the controller enable stable and reliable integration of the
comprehensive process control systems. The MG15 is able to support up to seven gauges, includ-
ing up to three passive and four active gauges. Optionally, the user may on placing an order choose
the number of supported passive (with hot cathode) and an additional communication interface
(ProiNet). In further part of the manual the device will be referred to as the ”MG15”.
1.3 SAFETY
The owner of the device must ensure that all the users have been informed about the safety require-
ments contained in this manual. In the event of sale or transfer of the device to another owner this
manual should be attached.
1.3.1 PERSONNEL QUALIFICATIONS
All work described in this document may only be carried out by persons who have suitable technical
training and the necessary experience or who have been instructed by the inal user of the device.
1.3.2 ILLUSTRATION OF RESIDUAL DANGERS
This user manual illustrates safety notes concerning dangers as follows:
1. Information on potential serious accident or personal injury.
User manual rev. 03 Page 11
To Next Page
Loading...
Need help?
General