Prevac MG15 - View of the Rear Panel of the MG15 with Optional PROFINET Interface

MULTI GAUGE CONTROLLER INSTALLATION
Figure 2.3: View of the rear panel of the MG15 with optional PROFINET interface.
The following connections are installed on the panel:
• A - Passive gauges connections
• B - Connections for passive gauges measuring signal
• C - Active gauges connections
• D - Fuse socket
• E - Ground terminal
• F - ProiNet communication interface
• G - I/O interface
• H - Air outlet
• I - Connection for relay outputs
• J - Mains connection
• K - Address DIP switch
• L - RS232/485 communication interface
• M - Ethernet communication interface
User manual rev. 03 Page 23