Prevac MG15 - Make Sure that no Objects Enter through the Vent Holes of the Device. Keep the Device Dry

MULTI GAUGE CONTROLLER INTRODUCTION
Fire of device.
If smoke or lames coming from the device are sighted, disconnect power sup-
ply immediately (by unplugging the power cord, or if it is not possible by dis-
connecting a relevant circuit in the switchboard powering the device). Remove
lammable materials at a safe distance. Start extinguishing the ire. If the power
supply could not be disconnected use only E-type extinguishers or dry-powder
extinguishers designed to extinguish equipment under voltage.
Improper installation, operation or use.
Improper installation, operation or use may damage the MG15 . Strictly adhere
to the stipulated installation and operation data.
Self-coniguration of the device.
Self-coniguration of the MG15 by the user through the service application re-
sults in waiver of the PREVAC’s liability for proper functioning of the device.
Figure 1.1: Make sure that no objects enter through the vent holes of the device. Keep the device
dry.
Failure to observe the general safety instructions may result in potentially dangerous situa-
tions.
User manual rev. 03 Page 13