Prevac MG15 - Page 71

MULTI GAUGE CONTROLLER OPERATION
• IP - adjusted manually if DHCP is disabled. Automatically set in the opposite case, when the
device is turned on.
• Mask - subnetwork mask (logically subdivision of an IP network).
• Brama domyślna - default gateway on a TCP/IP network,
• DHCP - Dynamic ”Host” Coniguration:
– enable - automatic coniguration on connection (IP address, gateway, subnet mask),
– disable -IP protocol parameters must be set manually,
• TCP server port - speciies the port number used in network socket created by TCP server,
default - 502
To change the Interface 2 parameters enter Setup menu →Device Settings →Communication
→Interface 2.
The detailed description of the RS232/485 connection pins is in: 2.5.3
• Interface - interface type:
– RS232
– RS485
– ProiNet
• Baud Rate:
– available Baud Rates: 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps,
115200 bps,
– 8 bits of data, 1 stop bit and no parity parameters are ixed and cannot be changed,
In the Communication menu, apart from the physical parameters of the communication interfaces,
the following parameters can be conigured:
• Remote Control - the option enables activation of the remote control mode. In the remote
control mode changing the parameters through the touch panel is locked. It is only possible
to view the parameters on the screen and view the device coniguration. The device in the
remote control mode displays in the upper part of the main window an information bar with
text: ”REMOTE: MG15 ”.
Activating the option does not mean that the device immediately switches to the remote con-
trol mode. It happens only after establishing communication with a remote control device.
Then the edition of the Remote Control option is locked and local control via the touch panel
is not possible. The remote control can be disabled only in two cases:
– failure of communication for more than 10s.
– sending a special command resulting in entering into the local control mode
Entering theRemote Control mode is necessary if the device must be controlled through a
communication interface. Reading of the parameters, however, is always possible and does
not require the mode to be activated.
• Address - current communication address of the device. Depending on the type of the device
this item can be edited, or can display the address that has been set on the DIP switch located
on the rear panel of the device.
User manual rev. 03 Page 71