Radwin WinLink 1000 - Page 344

WinLink 1000 User Manual Release1.9.40 Index 2
DFS 16-1
changing band for 20-5
Configuration 16-4
Link Activation 16-1
E
E1/T1 connections
Backup link 1-10
Environment
Interference 1-6
Ethernet Ring 13-1
1 + 1 13-6
operation 13-2
Protection Switching 13-6
purpose 13-1
setting up, ff 13-7
supported topologies 13-4
terminology 13-1
Events
color codes 9-16
log 9-2, 9-8
priority 9-16
F
Factory settings
revert to 8-1, 8-22, 9-20
FCC/IC DFS Installation Procedure 16-1
FEC A-1, A-1
G
Gateway 8-2
Telnet display 8-26
GSU A-6
Cascaded Sites 11-3
Configuring 11-5
Installation 11-4
Kit 11-4
Preferences 11-12
Redundancy 11-3
Software Update 11-13
Telnet Support 11-12
Transmission Phase 11-3, 11-9
Tx Transmission Ratio 11-9
use
functionality
scenarios 11-1
GUS
and RFP 11-8
H
HSS 10-1
and asymmetric allocation 10-11
Hardware Installation 10-3
IDU-C front panel LEDs 3-12, 10-12
ODU/HSS Connection Pinout 10-7, B-1
Radio Frame Pattern Table 10-7
HSS Client 10-2
Continue Transmission 10-3
Disable Transmission 10-3
HSS Master 10-2
Hub Site Synchronization, see HSS
I
IDU
Aging time 8-16
aging time, ODU Bridge Mode 8-16
Connecting to ODU 3-13
described 1-9
IDU-C
Alarm Connector B-3
Front panel 1-10, 1-10
Described 3-10
LEDs 3-11, 3-11, 4-3
Front panel LEDs for HSS
LEDs 3-12, 10-12
Mounting 3-10
Power connections 3-13, 3-13
IDU-E
Back Panel H-1
IDU-R
Back Panel 1-10, 3-10
Installing
IDU-R 3-10
Installing IDU-E and R units 3-9
Package Contents 3-4
IDU-C
Package Contents 3-4
IDU-E or IDU-R package contents 3-4
Indoor Unit, see IDU
Installation
Menu and Toolbar Functionality 6-3
Post Configuration main window 7-11
Post Installation main window 5-19
see Link, Installation
Installation Mode 8-2, 8-2, 8-17
Installing
BRS 25-1
Interference
caused by collocated units 10-2
Environment 1-6
Inventory 8-1, 8-11
Displaying 8-8
IP address 8-2
Telnet display 8-26