R&S RTC1000 User Manual

Remote Commands Reference
R&S
®
RTC1000
168User Manual 1335.7352.02 ─ 02
Available common commands:
*CAL?...........................................................................................................................168
*CLS.............................................................................................................................168
*ESE.............................................................................................................................168
*ESR?...........................................................................................................................168
*IDN?............................................................................................................................169
*OPC............................................................................................................................169
*OPT?...........................................................................................................................169
*PSC............................................................................................................................ 169
*RST.............................................................................................................................170
*SRE............................................................................................................................ 170
*STB?...........................................................................................................................170
*TRG............................................................................................................................ 170
*TST?........................................................................................................................... 170
*WAI.............................................................................................................................171
*CAL?
Performs a self-alignment of the instrument and then generates a status response.
Return values ≠ 0 indicate an error.
Usage:
Query only
*CLS
Clear status
Sets the status byte (STB), the standard event register (ESR) and the EVENt part of
the QUEStionable and the OPERation registers to zero. The command does not
alter the mask and transition parts of the registers. It clears the output buffer.
Usage:
Setting only
*ESE <Value>
Event status enable
Sets the event status enable register to the specified value. The query returns the con-
tents of the event status enable register in decimal form.
Parameters:
<Value> Range: 0 to 255
*ESR?
Event status read
Returns the contents of the event status register in decimal form and subsequently
sets the register to zero.
Common Commands

R&S RTC1000 Specifications

General

Brand	R&S
Model	RTC1000
Category	Test Equipment
Language	English