R&S RTC1000 - Page 241

Remote Commands Reference
R&S
®
RTC1000
241User Manual 1335.7352.02 ─ 02
Parameters:
<CenterFreq> Default unit: Hz
CALCulate:MATH<m>:FFT:FULLspan
Performs FFT calculation for the full frequency span.
Usage: Event
CALCulate:MATH<m>:FFT:SPAN <FreqSpan>
The span is specified in Hertz and defines the width of the displayed frequency range,
which is (Center - Span/2) to (Center + Span/2). The position of the span is defined
using the CALCulate:MATH<m>:FFT:CFRequency command.
Parameters:
<FreqSpan> Range: Depends on various other settings, mainly on time
base and span/RBW ratio.
Increment: Only 1 | 2 | 5 in first digit
Default unit: Hz
CALCulate:MATH<m>:FFT:STARt <StartFreq>
Defines the start frequency of the displayed frequency domain (instead of defining a
center frequency and span).
Parameters:
<StartFreq> Default unit: Hz
CALCulate:MATH<m>:FFT:STOP <StopFreq>
Defines the stop frequency of the displayed frequency domain (instead of defining a
center frequency and span).
Parameters:
<StopFreq> Default unit: Hz
CALCulate:MATH<m>:FFT:TIME:RANGe <WindowWidth>
Defines the width of the time base extract from the Y(t)-window for which the FFT is
calculated.
Parameters:
<WindowWidth> Range: depends on the time base
Default unit: s
FFT