R&S RTC1000 - Page 328

Remote Commands Reference
R&S
®
RTC1000
328User Manual 1335.7352.02 ─ 02
SYSTem:BEEPer[:IMMediate]......................................................................................... 330
SYSTem:BEEPer:TRIG:STATe....................................................................................... 331
SYSTem:BEEPer:CONTrol:STATe.................................................................................. 331
SYSTem:BEEPer:ERRor:STATe..................................................................................... 331
SYSTem:EDUCation:PRESet..........................................................................................331
CALibration
Calibration starts the self-alignment process. It can take several minutes. Consider
your timeout settings.
Calibration? returns information on the state of the self-alignment. Return values ≠
0 indicate an error.
Same as *CAL?.
Return values:
<SelfAlignment> Numeric status indicator
CALibration:STATe?
Returns the overall state of the self-alignment.
Return values:
<SelfAlignmentState> NOALignment | RUN | ERRor | OK | ABORt
NOALignment
No self-aligment was performed.
RUN
Self-aligment is running.
ERRor
Error occured.
OK
Self-aligment has been performed successfully.
ABORt
Self-aligment has been cancelled.
Usage:
Query only
DISPlay:LANGuage <Language>
Sets the language in which the softkey labels, help and other screen information can
be displayed. Supported languages are listed in the „Specifications“ data sheet.
Parameters:
<Language> ENGLish | GERMan | FRENch | SPANish | RUSSian |
SCHinese | TCHinese
*RST: Reset does not change the language
General Instrument Setup