Ricoh B132 - Page 153

COVER INTERPOSER TRAY (B704)
SM 1-107 B132/B200
Installation
Attach the Extensions to the B706
1. Attach the three shoulder screws [A] !"# ( x 3).
2. If the finisher was previously installed, remove the ground plate [B] from the
finisher and keep the screws.
3. Attach the bottom plate [C] ( x 2, M3 x 6).
4. Attach the ground plate to the bottom plate ( x 2).
5. Attach the bottom front cover extension [D] ( x 2, M4 x 8).
NOTE: Attach this cover first.
6. Attach the top front cover extension [E] ( x 2, M4 x 8).
7. Attach the rear cover extension [F] to the finisher ( x 2, M3 x 6).
8. Push up the bottom of the rear cover extension to close the gap at the top of
the cover, then tighten the screws.
B704I110.WMF
[A]
[B]
[C]
[D]
[E]
[F]
!
"
#