Ricoh B132 - Page 433

SERVICE CALL CONDITIONS
SM 4-33 B132/B200
FGATE error 1: Feedback remains LOW for Y write
SC233 D
After the start of timing to create
the yellow image, the PFGATE
register of the GAVD does not
assert, even after 5 sec. when:
• Images are created on the
drum.
• MUSIC patterns are created
on the transfer belt.
The BICU received a LOW
feedback signal, but the signal
remained LOW (indicating the
lasers were still operating), even
after creation of the next image
should have started.
• GAVD on the BICU defective
• PCI I/F on the IPU defective
• ASIC on the IOB defective
• Check board connections, replace
FGATE error 1: Feedback remains HIGH for M write
SC234 D
After the start of timing to create
the magenta image, the
PFGATE register of the GAVD
does not assert, even after 5
sec. when:
• Images are created on the
drum.
• MUSIC patterns are created
on the transfer belt.
The BICU received no feedback
(LOW signal) from the LD unit to
indicate that the lasers started
firing at the prescribed time to
create the patterns.
• GAVD on the BICU defective
• PCI I/F on the IPU defective
• ASIC on the IOB defective
• Controller board disconnected, defective
• Harness between the BICU LDB unit
disconnected, loose, or defective.
• Check board connections, replace
FGATE error 1: Feedback remains LOW for M write
SC235 D
After the start of timing to create
the magenta image, the
PFGATE register of the GAVD
does not assert, even after 5
sec. when:
• Images are created on the
drum.
• MUSIC patterns are created
on the transfer belt.
The BICU received a LOW
feedback signal, but the signal
remained LOW (indicating the
lasers were still operating), even
after creation of the next image
should have started.
• GAVD on the BICU defective
• PCI I/F on the IPU defective
• ASIC on the IOB defective
• Check board connections, replace