Ricoh B132 - Page 516

SERVICE PROGRAM TABLES
B132/B200 5-38 SM
007 PaperInt:2Pt Meas
Sets MUSIC to execute with 2-point measurement of
image page intervals.
[0~1/1]
008 JobInt:2Pt Meas
Sets MUSIC to execute with 2-point measurements
immediately before image output.
[0~1/1]
010 Interrupt Int
Sets the page interval beween MUSIC executions during
long jobs print jobs.
[10~300/1 page]
Note: This SP is effective only when SP2153 005 is
switched on.
012 MUSIC:Temp Chg
Prescribes the exposure unit temperature change at which
MUSIC executes at the start of a job.
[1~300/0.1 deg]
013 MUSIC:2Pt TempChg
Sets MUSIC to execute with 2-point measurement of the
room temperature change.
[1~300/0.1 deg]
014 MUSIC Density Lvl
Sets the density of the MUSIC test patterns. Note that the
default is set at the maximum setting.
[0~63/1]
015 Door Open:Wait
Sets the time interval for MUSIC to execute after the front
door is opened and then closed to remove a paper jam or
perform some other task.
[2~99/1 min.]
016 Clear Main Slip
Clears the skew correction amount for MUSIC in the main
scan direction.
[0~1/1]
020 Sensor Light 1 Sets the light intensity of MUSIC sensor 1.
[0~65535/1]
021 Sensor Light 2 Sets the light intensity of MUSIC sensor 2.
[0~65535/1]
022 Sensor Light 3 Sets the light intensity of MUSIC sensor 3.
[0~65535/1]
023 AutoLight:PreAdj
Executes automatic adjustment of the light emitted from
the MUSIC sensors.
[0~1/1]
025 AdjCoeff:FrontKf
Sets the value of the coefficient of the front MUSIC
sensor.
[0~100/0.1]
026 AdjCoeff:CtrKc
Sets the value of the coefficient for the center MUSIC
sensor.
[0~100/0.1]
027 AdjCoeff:RearKr
Sets the value of the coefficient of the center MUSIC
sensor.
[0~100/0.1]
028 Min Patch Fine
Sets the minimum amount of patch shift for MUSIC fine
adjustment.
[0~100/0.1]
029 Min Patch:Rough
Sets the minimum amount of patch shift for MUSIC rough
adjustment.
[0~100/0.1]