SERVICE PROGRAM TABLES
SM 5-53 B132/B200
Service Tables
2426 LEdgeCor:Norm FC Leading Edge Correction for Plain Paper: FC
This SP sets the coefficient used to 1) correct bias at the leading edge for full-color
image transfer (ITB) bias at image to paper transfer when using plain paper, and 3)
correct the dc and ac voltages applied at paper separation.
Notes: These settings apply:
• Only the distance from the leading edge set with SP2427.
•
Only to full color printing on plain paper at full speed.
001
ITB
[0~400/1%]
007
Side1:PTR
[0~400/1%]
008
Side1:SepDC
[0~400/1%]
009
Side1:SepAC
[0~400/1%]
012
Side2:PTR
[0~400/1%]
013
Side2:SepDC
[0~400/1%]
014
Side2:SepAC
[0~400/1%]
2427 LEdgeSWT:Norm FC Leading Edge Switch Timing for Plain Paper: FC
This SP sets switch timing that sets the distance from the leading edge where the
settings of SP2426 001 are to apply. The value selected is the number of mm from
the leading edge of the paper. These settings 1) apply only full-color printing on
plain paper at full speed, and 2) apply to to both sides of a duplex page.
001 ITB [0~30/1 mm]
002 PTR [0~30/1 mm]
003 SepDC [0~30/1 mm]
004 SepAC [0~30/1 mm]
2428 TEdgeCor:Norm FC Trailing Edge Correction for Plain Paper: FC
This SP sets the coefficient used to correct bias at image to paper transfer for each
side of the paper. These settings are applied to the trailing edge for full-color
printing on plain paper at full speed as far as where SP2429 002 takes effect.
007 Side1:PTR [0~400/1%]
012 Side2:PTR
2429 TEdgeSWT:Norm FC – PTR Switch Timing for Plain Paper: FC
This setting sets the start timing for application of SP2428 007, 2428 012 at the
trailing edge of each sheet (Side 1, Side 2). These settings are applied to the
trailing edge for black printing on plain paper at full speed and apply to black, even
when printing in full color mode.
[-100~0/1 mm]
The mm distance is measured away from the trailing edge of the image.
To Next Page
Loading...
