SERVICE PROGRAM TABLES
SM 5-79 B132/B200
Service Tables
2903 Env Thresh:K_PCU Room Temperature Correction Threshold: PCU
This SP sets the threshold value of LL and ML for the current room temperature.
001 Abs Humid:Thresh1 [0~10000/0 g/m
3
]
002 Abs Humid:Thresh2 [0~10000/m
3
]
003 Abs Humid:Thresh3 [0~10000/m
3
]
004 Abs Humid:Thresh4 [0~10000/m
3
]
2904 Blade Bend Ctrl Blade Bend Prevention Pattern Control
A blade-bend prevention pattern is created with K toner on the ITB between every
copy image to lubricate the ITB cleaning blade so it will not bend or scour the surface
of the ITB. These SPs set 1) pattern creation interval, 2) density of the pattern, 3)
whether the pattern is displayed.
Note: This function is OFF. Changing this setting is normally not required for this
machine.
001 Pattern Interval Sets the number of pages between patterns.
[0~200/1 pg.]
002 Pattern Light Sets the density of the pattern.
[0~63/1]
003 Page Cnt Disp
Displays the count for the number of blade prevention
patterns.
[0~200/1 pg.]
2905 Used Toner Mtr 2 Used Toner Motor 2 Control
The waste toner bottle is provided with a near-full sensor and an augur that evenly
distributes the used toner inside the bottle. To extend the life of the waste toner bottle
near-full motor that rotates this augur, the motor and augur do not operate
continuously. The motor is turned on only after a prescribed amout of toner has been
consumed.
001 Toner Consumed Sets the amount of toner to be used before the toner
[1~10/1 g]
002 Waste Tnr M Time Sets the amount of time the motor remains on.
[1~10/1 sec.]
To Next Page
Loading...
