Ricoh D129 - Page 1039

Error Codes
SM 21 D629
Fax Option
Type 5002
(D629)
Code Meaning Suggested Cause/Action
0-07 No post-message response
from the other end after a
page was sent
 Check the line connection.
 Replace the FCU.
 The other end may have jammed or run
out of paper.
 The other end user may have
disconnected the call.
 Check for a bad line.
 The other end may be defective; try
sending to another machine.
0-08 The other end sent RTN or
PIN after receiving a page,
because there were too many
errors
 Check the line connection.
 Replace the FCU.
 The other end may have jammed, or run
out of paper or memory space.
 Try adjusting the tx level and/or cable
equalizer settings.
 The other end may have a defective
modem/FCU; try sending to another
machine.
 Check for line problems and noise.
Cross reference
 Tx level - NCU Parameter 01 (PSTN)
 Cable equalizer - G3 Switch 07 (PSTN)
 Dedicated Tx parameters in Service
Program Mode
0-14 Non-standard post message
response code received
 Incompatible or defective remote terminal;
try sending to another machine.
 Noisy line: resend.
 Try adjusting the tx level and/or cable
equalizer settings.
 Replace the FCU.
Cross reference
See error code 0-08.