Installing Controller Options
D641 20 SM
"ANT1" is a transmission/reception antenna and "ANT2" is a reception antenna. Do
not attach them at the wrong places.
7. Attach the clamps as shown above.
8. Wire the cables and clamp them (
x 8).
Make sure that the cables are not slack. Keep them wired tightly along the covers.
You may have to move the machine if the reception is not clear.
Make sure that the machine is not located near an appliance or any type of equipment that
generates strong magnetic fields.
Put the machine as close as possible to the access point.
User Tool Settings for IEEE 802.11a/g
Go into the User Tools mode and do the procedure below. These settings take effect every time
the machine is powered on.
You cannot use IEEE 802.11a/g if you use Ethernet.
1. Press the “User Tools” key.
2. On the touch panel, touch “System Settings”.
Select “Interface Settings”> “Network” > “LAN Type”. The “LAN Type” (default:
Ethernet) must be set for either Ethernet or wireless LAN.
3. Select “Interface Settings”> “Wireless LAN”. Only the wireless LAN options show.
4. Set the “Communication Mode“.
5. Enter the “SSID setting”. (The setting is case sensitive.)
6. Set the “Ad-hoc Channel”. You need this setting when Ad Hoc Mode is selected. The allowed
range for the channel settings may vary for different countries.
Region A (mainly Europe and Asia)
Range: 1-13, 36, 40, 44 and 48 channels (default: 11)
To Next Page
Loading...
