shooting
03 -
Paper feed motor error
The error flag of the paper feed motor driver IC is asserted when the jam
error is issued.
Pick-up motor driver detected an error.
Turn the main switch off and on.
720 B 2000/3000-Sheet (booklet) Finisher Error
-24 -
Finisher exit guide plate motor error
After moving away from the guide plate position sensor, the exit guide is not
detected at the home position within the prescribed time.
The 1st detection failure issues a jam error, and the 2nd failure issues this
SC code.
Guide plate motor disconnected, defective
Guide plate motor overloaded due to obstruction
Guide plate position sensor disconnected, defective
-25 -
Finisher punch motor error
The punch HP sensor is not activated within the specified time after the
punch motor turned on.
The 1st detection failure causes a jam error, and the 2nd failure causes this
SC code.
Punch HP sensor disconnected, defective
Punch motor disconnected or defective
Punch motor overload due to obstruction
To Next Page
Loading...
