Ricoh D129 - Page 521

Service Call Conditions
D129/D130 6-32 SM
-30 -
Finisher jogger motor error
The jogger fences move out of the home position but the HP sensor output
does not change within the specified number of pulses.
The 1st failure issues an original jam message, and the 2nd failure issues
this SC code.
 Jogger HP sensor disconnected, defective
 Jogger motor disconnected, defective
 Jogger motor overloaded due to obstruction
 Finisher main board and jogger motor
-41 -
Stack feed-out motor error
 The stack feed-out HP sensor does not detect the home position of the
stack feed-out belt 3000ms after the stack feed-out belt has moved to its
home position.
 The stack feed-out HP sensor does not turn off 200 ms after the stack
feed-out belt has moved from its home position.
The 1st detection failure causes a jam error, and the 2nd failure causes this
SC code.
 Defective stack feed-out HP sensor
 Overload on the stack feed-out motor
 Defective stack feed-out motor
 Defective main board
 Disconnected or defective harness
-42 -
Finisher stapler movement motor error
Staple movement is not finished within a certain time.
The 1st detection failure causes a jam error, and the 2nd failure causes this
SC code.
 Motor overload
 Loose connection of the stapler home position sensor
 Loose connection of the stapler movement motor
 Defective stapler home position sensor
 Defective stapler movement motor