Ricoh D129 - Page 529

Service Call Conditions
D129/D130 6-40 SM
-44 -
Corner stapler motor error
The 1st detection failure issues a jam error, and the 2nd failure causes this
SC code.
 The stapler motor does not switch off within the prescribed time after
operating.
 The HP sensor of the staple unit does not detect the home position after
the staple unit moves to its home position.
The HP sensor of the staple unit detects the home position after the staple
unit moves from its home position.
 Staple jam
 Number of sheets in stack exceeds allowed number of sheets for
stapling
 Stapler motor obstructed
 Stapler motor defective
-70 -
Tray lift motor error
The tray lift motor is not operating.
 Motor harness loose, broken
 Motor drive obstructed
 Stack height sensor dirty, harness loose, broken
 Motor defective
 Stack height sensor defective
-71 -
Shift tray motor error
The shift tray motor is not operating.
 Shift motor drive is obstructed (jammed paper, paper scraps, etc.)
 Shift motor harness loose, broken
 Shift tray HP sensor harness loose, broken
 Shift motor defective
 Shit tray HP sensor defective