Ricoh D129 - Page 528

Service Call Conditions
SM 6-39 D129/D130
Trouble-
shooting
-30 -
Front fence motor error
The jogger fence motor in the finisher is not operating.
 Jogger motor drive is obstructed (jammed paper, paper scraps, etc.)
 The motor harness is loose or broken
 Jogger fence HP sensor dirty, loose, defective
 Jogger fence motor defective
-41 -
Feed-out belt motor error
The feed-out belt did not return to the home position within the prescribed
time.
 Feed-out belt motor drive is obstructed (jammed paper, paper scraps,
etc.)
 Motor harness loose or broken
 Feed-out belt HP sensor dirty, disconnected, broken
 Motor defective
-42 -
Stapler movement motor
The 1st detection failure issues a jam error, and the 2nd failure causes this
SC code.
The stapler HP sensor is not activated within the specified time after the
stapler motor turned on.
 Stapler or motor drive is blocked by obstruction
 Motor harness loose or broken
 Stapler HP sensor harness loose, broken
 Motor defective
 Stapler HP sensor defective