System SP Table-1
SM Appendix 3-7 D129/D130
Service
Program
Mode Tables
028
Feed Wait: Center Minus: Plain
Adjusts the offset value for each re-load
temperature to exit the feed waiting
mode.
[0 to 60 / 0 / 1 deg]
029
Feed Wait: Ends Minus: Plain
030
Feed Wait: Center Minus: M-Thick
031
Feed Wait: Ends Minus: M-Thick
032
Feed Wait: Center Minus: Thick 1
033
Feed Wait: Ends Minus: Thick 1
034
Feed Wait: Center Minus: Thick 2
035
Feed Wait: Ends Minus: Thick 2
036
Feed Wait: Center Minus: Thin
037
Feed Wait: Ends Minus: Thin
038
Feed Waiting: Maximum Time
Sets the maximum feed waiting time.
[0 to 30 / 0 / 1 sec]
The paper is fed when the time specified
with this SP has passed even though the
fusing temperature has not reached the
prescribed temperature.
0: Disabled.
1106 Fusing Temperature Display
001 Roller Center Displays the temperature of the fusing
unit.
[-20 to 250 / 0 / 1 deg]
002 Roller Ends
003 Machine Inside at Power On Displays the temperature inside the
machine.
[-20 to 250 / 0 / 1 deg]
004 Machine Inside
To Next Page
Loading...
