Service
Program
Mode Tables
005
By-pass: Image Area
C2b: [10 to 100 / 35 / 1
A]
C2c: [10 to 100 / 45 / 1
A]
Adjusts the transfer current for copying from the by-pass tray.
If the user normally feeds thicker paper from the bypass tray, use a higher
setting.
006
By-pass: Leading Edge
[10 to 100 / 20 / 1
A ]
Adjusts the transfer current for copying at the leading edge of paper fed
from the by-pass tray.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
008
No Image Area (SSP)
[10 to 100 / 15 / 1
A ]
Adjusts the transfer current for copying.
2309* Current: Paper Size Correction (SSP)
001
Paper Lower Width (a) [1 to 150 / 150 / 1 mm ]
Adjusts the lower paper width threshold for the transfer current, charge
voltage, and development bias corrections.
Use this SP when an image problem (e.g., insufficient toner transfer) occurs
with a small width paper. If the paper width is smaller than this value, the
transfer current will be multiplied by the factor in SP2-309-3 (paper tray) or
SP2-309-5 (by-pass).
002
Paper Upper Width (a) [151 to 296 / 216 / 1 mm ]
Adjusts the upper paper width threshold for the transfer current, charge
voltage, and development bias corrections.
As for SP2-309-1, but the factors are in SP2-309-4 (paper tray) and
SP2-309-6 (by-pass).
To Next Page
Loading...
