Service
Program
Mode Tables
2940* Toner consump. (SSP)
001
[0: OFF 1: ON] [0 to 1 / 1 / 1]
If this SP is set to ON, toner bottle consumes toner when the SP2801 (TD
Sensor Initial Setting) is executed. This prevents the image offset.
002
Setting [0 to 1 / 0.06 / 0.01]
Specifies the threshold value for the toner consumption mode if
SP2940-001 is set to ON.
2960*
Toner Overflow Sensor [0 = OFF, 1= ON]
Selects whether or not the toner overflow sensor is activated.
2964*
Trans Cleaning Blade Forming (SSP)
Applies a pattern of toner to the transfer belt at a defined interval between
sheets on the transfer belt in order to reduce friction between the belt
surface and the cleaning blade.
Under conditions of high temperature and high humidity, the density control
feature may reduce the amount of toner, which also reduces the amount of
toner on the surface of the transfer belt. With less toner on the belt, the
friction between the belt and the blade increases, and could cause the blade
to bend or scour the surface of the belt.
001 0: OFF, 1: ON [0 to 1 / 0 / 1 ]
002 Pattern Interval [1 to 100 / 15 / 1 sheet]
003 Pattern Number [1 to 3 / 1 / 1 line]
004 Pattern LD Power [0 to 15 / 2 / 1 ]
To Next Page
Loading...
